Skip to content

Roof Pressure Washing in Homestead, FL

Roof pressure washing here means a low-pressure soft wash with a roof-safe cleaner. Fast Pro removes dark algae streaks, mildew, and moss from shingle, tile, flat, and metal roofs without stripping the surface, and clears and flushes your gutters in the same visit.

Serving Homestead, FL homeowners. 6+ years of experience. 450+ jobs completed. Last updated .

A roof mid-wash with a clean line against dark streaks at a Homestead home

Every roof wash includes

Soft wash only
  • Soft wash, never a pressure blaster
  • Roof-safe cleaner matched to the material
  • Gutters cleared first and flushed after
  • Plants covered and rinsed
  • Damage flagged, not hidden
  • Before and after photos

Roof pressure washing in Homestead, FL

Homestead roofs are concrete tile, metal, shingle and flat, and heat and humidity grow algae on all of them. We soft wash with a roof-safe cleaner, match the method to the material and clear the gutters before and after.

Roof cleaning advice usually assumes asphalt shingles. Homestead roofs are a mix: concrete tile on many subdivision homes, metal on farmhouses and outbuildings, shingle on older houses and flat roofs on some low-slope homes. None of them should be blasted with a high-pressure washer.

Heat and rain keep roofs damp, and algae follows. In South Florida the black streaks are commonly an algae called Gloeocapsa magma. It shows first on shaded slopes and under trees. Flat roofs collect a dirt film and mildew where water ponds, and summer dust settles over all of it.

Tile takes the most care. Tile makers' care guides, citing Tile Roofing Institute guidance, cap cleaning pressure near 1,200 psi and call for a cleaner that is compatible with concrete. They also say to step on the bottom few inches of installed tile, where tiles overlap. We soft wash at a small fraction of that pressure and plan the route across the roof before the first step. On metal we use low pressure and a coating-safe cleaner, and we work from stable footing.

Homestead is inside Miami-Dade's High-Velocity Hurricane Zone, where roofing products need a Miami-Dade Notice of Acceptance. We clean. Repairs and re-roofing go to a licensed roofer, and when we see cracked tile, lifted edges or loose fasteners we photograph them for you.

Homestead roofs run from concrete and clay tile on many subdivision homes to metal and shingle on older houses and farm buildings, plus flat roofs on some low-slope homes. August highs average 92°F, and the humid air grows algae and mildew on all of them. On tile we limit pressure, choose a cleaner that is compatible with concrete, and step only where the tiles overlap. On metal we wash at low pressure and watch our footing, because wet metal is slick.

Homestead is inside Miami-Dade County's High-Velocity Hurricane Zone, and roofing products installed there need a Miami-Dade Notice of Acceptance. The county tightened its building code after Hurricane Andrew. We clean roofs. Repairs and re-roofing belong to a licensed roofer.

What grows on a roof, and how we clean each type

The right method depends on the roof material. We match the cleaner and the footing to it.

Roof types, what grows on them, and how we clean them
Roof typeWhat grows or builds upHow we clean it
Asphalt shingleDark algae streaks, moss, and lichenRoof-safe cleaner, low-pressure rinse, never a pressure blaster
Concrete or clay tileDark algae, mildew, and moss in the valleysSoft wash, careful footing, and a rinse that follows the tile pattern
Flat or low-slope roofMildew, dirt film, and standing-water stainsLow-pressure wash with a membrane-safe cleaner, drains cleared
MetalDirt film, mildew, and oxidationGentle wash and rinse that will not scar the coating

On asphalt shingles the dark streaks are usually a cyanobacterium called Gloeocapsa magma, which feeds on the limestone filler in the shingle and spreads on the wind, as the Asphalt Roofing Manufacturers Association explains. Warm, humid, shaded roofs grow it fastest.

Soft wash or pressure washing?

This is the question that decides whether a roof cleaning helps your roof or hurts it.

High-pressure blasting compared with low-pressure soft wash on a roof
On your roofHigh-pressure blastingOur low-pressure soft wash
ShinglesKnocks off protective granules.Granules stay in place.
Algae and mildewRoots stay and streaks return sooner.Cleaner kills growth at its base.
Water intrusionCan force water under the roof surface.Gentle flow that follows the way rain runs.
Tile, flat, and metalCan chip tile and scar coatings and membranes.Safe on tile, flat roofs, metal, and shingle.

We use a soft wash on every roof. The cleaner does the work, and the water only carries it off. That is slower than blasting, and it is the reason your roof comes out of it in one piece.

How we wash a roof

Gutters first, roof second, gutters again at the end.

  1. 1

    We inspect and plan

    We check the material, the pitch, the condition of the surface, and the safest way up. Loose or damaged areas get flagged before we start.

  2. 2

    We clear the gutters

    Debris comes out first so the rinse has a clear path and the roof does not wash dirt into a full trough.

  3. 3

    We protect the plants

    Shrubs and flower beds under the roof line are wet down and covered.

  4. 4

    We apply the roof-safe cleaner

    The cleaner goes on at low pressure and sits long enough to kill the growth at its base.

  5. 5

    We rinse gently

    A low-pressure rinse carries the cleaner and the dead growth down and off, the way rain would.

  6. 6

    We flush the gutters again

    Runoff from the roof leaves through the gutters and downspouts, so we flush them a second time.

  7. 7

    We photograph the result

    You get before and after photos and a note on anything we saw that needs a roofer.

A roof mid-wash with a clean line against dark streaks at a Homestead home

Streaks fade as the cleaner works. The rinse only carries them off.

Before and after: a roof soft washed

The same roof, photographed from the same spot before and after.

Before roof washing in Homestead: a roof with dark algae streaks
Before: streaked roof
After roof washing in Homestead: the same roof, clean
After: the same roof, clean

Safety, and what we leave to roofers

Roofs are dangerous places. We use the right ladder angle (see NIOSH guidance), we walk only on surfaces that can take it, and we never use high pressure. If a roof is too steep, too fragile, or too damaged to wash safely, we say so.

We clean roofs. We do not repair or replace them. When we find damaged roofing, we photograph it and tell you plainly, so a licensed roofer can take it from there.

ZIP codes where we wash roofs in Homestead

Pick your ZIP code to see the neighborhoods we cover, or call and we will confirm your street.

View all 6 ZIP codes

Not sure we cover your ZIP code? Call us at (813) 856-2726.

Roof pressure washing questions, answered

How much does gutter cleaning cost in Homestead?

The price depends on the feet of gutter, the number of stories, how packed the runs are and whether guards are installed. Homestead homes range from short runs over a front door to gutters around the full roofline. Call with your ZIP code and we quote by phone.

How much does roof cleaning cost in Homestead?

It depends on the roof size, the material, the pitch and how much algae is on it. A one-story concrete tile roof, a metal roof on a farmhouse and a two-story shingle roof are different jobs. Tell us the roof type and the stories and we quote by phone.

When is the best time to clean gutters in Homestead?

Early May, before rain climbs from 2.9 inches in April to 5.8 inches in May. A second visit between mid-October and December clears what hurricane season left. Homes under mango or avocado trees may need a third look in late summer.

How often should a Homestead roof be cleaned?

Every two to three years suits most roofs. Slopes under trees go dark sooner.

Do you clean gutters and roofs after a hurricane or tropical storm?

Yes. After a named storm we move cleanups up the schedule, clear fronds, branches and leaf mats from the roof and the trough, and flush every downspout.

Do you work on houses in Redland and on farm properties?

We clean houses and their roofs, including homes on large Redland lots. Packing houses, greenhouses and other commercial buildings are outside our work.

Is it safe to pressure wash a tile or metal roof in Homestead?

Pressure is the risk. Tile care guides cap cleaning pressure near 1,200 psi and warn that some cleaners etch concrete. On tile we soft wash with a compatible cleaner. On metal we keep pressure low and avoid scuffing the coating.

Can you clean a metal roof in Homestead?

Yes, at low pressure with a coating-safe cleaner. We avoid scrubbing that dulls the finish and we work from secure footing.

How soon will the algae come back?

Shaded slopes darken first. Most roofs go two to three years between washes, and roofs under trees sometimes need it sooner.

Should the gutters be cleaned before or after the roof wash?

Both. We clear the gutters first so debris has a clear path, wash the roof, then clear the gutters again.

Dark streaks on your roof?

Call and tell us the roof material and what you see. We quote by phone and find a day that works.

Call (813) 856-2726
Call (813) 856-2726